SU-04249 - Front Ski Gas Shock Assembly for Polaris Snowmobiles

Sold Each some machines may take multiples

Use original spring & retainer where applicable

Low pressure gas cell design shock

Maintenance free - non rebuildable

Gas shocks offer fade free performance

High quality for superior strength

Produced to OEM specifications

Made using the Finest Materials and Advanced Technologies

One very important point about shock absorbers is that shock absorbers do not support the Snowmobile or ATV weight. Instead, the primary purpose of the shock absorber is to dampen spring and suspensions movement. If your snowmobile or ATV is sagging the problem isn't the shock but the suspension spring(s).

Standard hydraulic shock absorbers use air and oil to cushion the stroke of the shock absorber. A gas shock replaces the air in the shock with pressurized nitrogen gas. The nitrogen in the gas shock keeps it cooler than a hydraulic shock. Also when a hydraulic shock is used on a rough surface (ie: washboard) the hydraulic oil foams or forms bubbles thus reducing it effectiveness. The nitrogen in gas shock absorbers helps to eliminate the potential for the oil to foam.

An additional benefit of a gas shock absorber is that it creates a mild boost in spring rate to your ATV or Snowmobile. This does not mean that a gas charged shock would raise the vehicle up to correct ride height if the springs were sagging.

Check fitment in expandable chart below.