Replacement Shock for Polaris Snowmobiles. Not OEM. Application:
97-98 Indy 600 XCR
98-99 Indy 700 XCR
99 Indy 800 XCR
97-98 Indy Storm, SE
97-98 Indy Ultra SPX, SE
One very important point about shock absorbers is that shock absorbers do not support the Snowmobile or ATV weight. Instead, the primary purpose of the shock absorber is to dampen spring and suspensions movement. If your snowmobile or ATV is sagging the problem isn't the shock but the suspension spring(s).
Standard hydraulic shock absorbers use air and oil to cushion the stroke of the shock absorber. A gas shock replaces the air in the shock with pressurized nitrogen gas. The nitrogen in the gas shock keeps it cooler than a hydraulic shock. Also when a hydraulic shock is used on a rough surface (ie: washboard) the hydraulic oil foams or forms bubbles thus reducing it effectiveness. The nitrogen in gas shock absorbers helps to eliminate the potential for the oil to foam.
An additional benefit of a gas shock absorber is that it creates a mild boost in spring rate to your ATV or Snowmobile. This does not mean that a gas charged shock would raise the vehicle up to correct ride height if the springs were sagging.
|OEM Replacement This part is aftermarket equipment designed to replace the original manufacturer's part numbers specified here. It is manufactured using high-quality materials, to the same specifications as the original part.||Polaris 7041540, Kimpex 08-165|
|Shock Bottom Eye Diameter||10 mm|
|Shock Length Closed||10-1/2"|
|Shock Length Open||15-3/4"|
|Shock Top Eye Diameter||10 mm|
This part fits:
- Indy 600 XCR
- Indy 700 XCR
- Indy 800 XCR
- Indy Storm
- Indy Storm SE
- Indy Ultra SPX